Baytech RPC Single-phase Conbined QS Manuel d'utilisateur télécharger pdf (Page 45)

RPC with or without Ethernet

Select A) to add a rule. Type an IP address, select whether to drop or accept the address. The RPC will

display the following:

Selecting either DROP or ACCEPT the packets and the RPC will assign filter the next rule number:

Selecting E), Enable IP Filtering will enable or disable the filtering function. The RPC displays:

Select V), View Rules allows the user to see any IP filtering. Note: At least one rule must be defined

for this option to be available. The RPC displays:

Select C), Set Default Target for ALL IP Addresses to accept or drop all. The RPC displays:

Filter Management Menu

Enter request or CR,X to exit menu.

A)...Add Rule

E)...Enable IP Filtering

D)...Delete Rule

V)...View Rules

F)...Flush Rules

C)...Set Default Target

Enter Request :a

Add a Rule

Please enter a single ip address filter

or an ip address block in ip/<blockmask> notation.

: 70.150.140.95

Select a target option for this filter:

DROP the packet..................1

ACCEPT the packet................2

Exit.............................X,CR

Enter Request :1

Filter added as Rule 1.

IP Filtering is ENABLED. Enable? (Y/N): y

Rule Num Ip Address Target

1 70.150.140.95 DROP

2 70.150.140.96 ACCEPT

Strike ENTER to continue

The default target is............ACCEPT

DROP ? (Y/N), CR for no change) :y

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

Pas de commentaire

Baytech RPC Single-phase Conbined QS Manuel d'utilisateur Page 45