Baytech RPC Single-phase Conbined QS Manuel d'utilisateur télécharger pdf (Page 33)

RPC with or without Ethernet

Configuration Menu:

NOTE: If the unit display with the following message, “Configuration mode in use” A user

in the other port is in the “Configuration” menu

URPC Ethernet Host Module

Revision F 1.07.05 Module 1

Hardware 1.01 Serial number 3800024 colilo version 1.05.01

Status..........................1 Status of all network options

Serial Port Configuration.......2 Setup the Serial port EIA232

Serial Port Device Name.........3 Change the EIA232 port name

Attention Character.............4 Type 5 times to access Network Main menu.

Disconnect Timeguard............5 Data received within the delay period,

is data, not attention character; thereby

preventing unwanted port disconnection

Connect Port ID Echo............6 Echo port name or module# & port#

access control, manage users

Network Port Configuration......8 Network Port IP Address

Module Name.....................9 Change name of module

SNMP Configuration.............10 Trap address, Read/Write community names,

Enable/Disable SNMP

RPC Management.................11 Set up Voltage/Current/Sensor threshold

Web Server Configuration.......12 Enable/Disable Web, login, secure.

Radius Configuration...........13 Enable login, IP Address, Backup server,

Exit.........................X,CR

Enter Request :

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

Pas de commentaire

Baytech RPC Single-phase Conbined QS Manuel d'utilisateur Page 33